© 2000-2006 AATcorp

Make better use of your small and visually restricted side mirror. This direct replacement stick on convex mirror makes "objects in the mirror closer than they appear", just like on the new cars.

The exceptionally wider view provides more visual information and less blind spots over large bulbous rear fenders and flares. The protective border around the lens finishes off the mirror with a clean OEM type look.

Simply peel off the adhesive backing and stick over the original glass without damage if you need to remove it later.

A great safety enhancement to any car!

Choose either the 4 power expanded view version or the 8 power super wide angle ratio model. The 4:1 Expanded View™ mirror opens up your rear field of view by 4 times the area while still allowing visual identification of distant objects coming into view. The 8:1 Super Wide Angle View™ mirror increases the rearward field of view by 8 times allowing visual tracking of a wider area but limiting distant object's to as closer range of focus.

The 4:1 Expanded View™ mirror is a great improvement over standard flat mirrors in allowing a better angle of vision while still retaining a clear notification of far away distant objects. This is an excellent compromise of both flat glass mirrors and super wide angle convex mirrors. Works excellent on a cobra with wide fenders allowing you to see close as well as far away object!

The 8:1 Super Wide Angle View™ mirror is a great asset in capturing a wide area of vision especially beneficial in making blind lane changes allowing you to virtually see the vehicle next to you without turning your head and taking your eyes off the road.

ALTERNATE INSTALLATION OPTIONS:

Sometimes the edges of the add-on mirror contacts the rim of the originasl mirror's frame, thus not allowing full contact of the mirror at the adhesive base. Here is a better method of attaching the mirror in those cases;

1.  Remove all the adhesive from the back of the add-on Mirror.

2.  Clean the back of the add-on mirror's surface as well as the glass of the original mirror with alcohol.

3.  Using Clear 100% Silicone sealant, place a perfectly round "blob" of sealant of about 1/2" to 3/4" in
     diameter on the factory mirror glass directly in the center.

4.  Slowly press the add-on mirror onto the factory glass to allow the excess sealant ooze over the surface
     as you continue to push. If you place the right amount on, NO sealant should have escaped from around
     the edges.

5.  Secure with masking tape and allow to dry.

6.  The "suction" effect and pliability of the sealant should never let the mirror fall off, yet the sealer
     should allow easy removal if necessary without damage to any part.